**********************************************************************
If LPRng is not activated at installation time,
to activate the LPRng printing system do the following:

On FreeBSD:
  set'lpd_enable=NO' and 'lprng_enable=YES' in /etc/rc.conf.
  The LPRng startup script is in /usr/local/etc/rc.d/lprng.sh

  If lprng_enable != NO then the LPRng lpd will run.

- run 'checkpc -f' to make sure that necessary files have been created

- reboot or kill the old lpd using 'killall lpd' and
  start the new one using '%%PREFIX%%/etc/rc.d/lprng.sh start'.

LPRng uses the printcap, lpd.conf, and lpd.perms configuration files

For further information, see the LPRng Documentation:
  %%DOCSDIR%%

The LPRng Web Site is http://www.lprng.com

Commercial support is available from Astart Technologies:

Patrick Powell                 Astart Technologies
papowell@astart.com            6741 Convoy Court
Network and System             San Diego, CA 92111
  Consulting                   858-874-6543 FAX 858-751-2435
LPRng - Print Spooler (http://www.lprng.com)
**********************************************************************